Yamaha RX-D485 - Adjusting the Volume of each Speaker; Setting the Equalizer

Adjusting the volume of each speaker
Adjusts the volume of each speaker to suit your listening position.
Setup menu
“Speaker” > “Level”
Choices
Front L, Front R, Center, Surround L, Surround R, Subwoofer
Setting range
-10.0 dB to +10.0 dB (0.5 dB increments)
NOTE
Test tone output helps you to adjust the speaker balance while confirming its effect. For details, see the
following:
▪ “Outputting test tones” (p.98)
Setting the equalizer
Selects the type of equalizer to be used and adjusts the tone.
Setup menu
“Speaker” > “Equalizer” > “EQ Select”
Settings
PEQ
Applies the parametric equalizer values obtained by the YPAO
measurement.
GEQ Select this option when you want to adjust the equalizer manually.
Off Does not use the equalizer.
When selecting “GEQ”
1
Use the cursor keys to select “Channel” and to select the desired
speaker channel.
2
Use the cursor keys to select the desired band (frequency) and to
adjust the gain.
Setting range
-6.0 dB to +6.0 dB
3
Press SETUP.
This completes the settings.
NOTE
▪ Test tone output helps you to adjust the equalizer while confirming its effect. For details, see the following:
– “Outputting test tones” (p.98)
▪ “PEQ” is available only when the YPAO has been performed. For details on the YPAO, see the following:
– “Optimizing the speaker settings automatically (YPAO)” (p.33)
En
97