What to do if my Yamaha RX-V1400 Receiver displays E-9 USER CANCEL?
If your Yamaha Receiver displays 'E-9:USER CANCEL', it means the auto setup procedure was canceled because a setting which affects the auto setup was changed during the procedure. Perform the auto setup procedure again.
What to do if my Yamaha RX-V1400 Receiver displays W-4 SWFR PHASE?
If your Yamaha Receiver displays 'W-4:SWFR PHASE', it means the phase polarity of the subwoofer is not correct. If the subwoofer has a phase switch, we recommend that you select the opposite phase on the subwoofer.
How to connect the optimizer microphone to Yamaha RX-V1400 Receiver?
The message 'Connect MIC!' on your Yamaha Receiver indicates that the optimizer microphone is not connected. Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel.
What to do if my Yamaha RX-V1400 Receiver displays E-4 SBR->SBL?
If your Yamaha Receiver displays 'E-4:SBR->SBL', it means only the right surround back channel signal is detected. Connect the surround back speaker to the LEFT SURROUND BACK SPEAKERS terminal if you only have one surround back speaker.
What to do if my Yamaha RX-V1400 displays W-5 VOL ERROR?
If your Yamaha Receiver displays 'W-5:VOL ERROR', the result may not be correct because the volume was changed during the auto setup procedure. Perform the auto setup procedure again, and do not change the volume during the auto setup procedure.
What to do if my Yamaha Receiver displays E-6 CHECK SURR.?
If your Yamaha Receiver displays 'E-6:CHECK SURR.', it means surround back speaker(s) is (are) connected, though surround L/R speakers are not. Connect surround speakers when you use (a) surround back speaker(s).
What to do if my Yamaha Receiver displays E-3 NO PRES. SP?
If your Yamaha Receiver displays 'E-3:NO PRES. SP', it means a presence channel signal is not detected. Check the presence speaker connections.
What to do if my Yamaha RX-V1400 displays W-1 OUT OF PHASE?
If your Yamaha Receiver displays 'W-1:OUT OF PHASE', it indicates that the speaker polarity is not correct. Check the speaker connections. Note that this message may appear depending on the speakers even when the speakers are connected correctly.
What to do if my Yamaha Receiver displays E-8 NO SIGNAL?
If your Yamaha Receiver displays 'E-8:NO SIGNAL', it means the optimizer microphone does not detect test tones. Check the microphone setting, and also check the speaker connections and placement.
What to do if my Yamaha Receiver displays E-2 NO SURR.SP on my Yamaha Receiver?
If your Yamaha Receiver displays 'E-2:NO SURR.SP', it indicates that a surround channel signal is not detected. Check the surround speaker connections.
To Next Page
General
