What to do if my Yamaha Receiver displays E-7 NO MIC?
If your Yamaha Receiver displays 'E-7:NO MIC', it means the optimizer microphone was unplugged during the auto setup procedure. Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel.
What to do if my Yamaha Receiver shows W-3 LEVEL ERROR?
If your Yamaha Receiver shows 'W-3:LEVEL ERROR', it means the volume level difference among the speakers is excessive. To resolve this: 1. Readjust the speaker installation. 2. Check the speaker connections. 3. Use speakers of similar quality. 4. Adjust the output volume of the subwoofer.
What to do if my Yamaha Receiver displays E-1 NO FRONT SP?
If your Yamaha Receiver displays 'E-1:NO FRONT SP', it means the front L/R channel signal(s) is (are) not detected. Make sure you select the front speakers using SPEAKER A or B. Also, check the front L/R speaker connections.
What to do if my Yamaha RX-V1400 shows error E-5 NOISY?
If your Yamaha Receiver displays the error 'E-5:NOISY', it indicates that the background noise is too loud. Try performing the auto setup procedure in a quiet environment. Also, turn off any noisy electrical equipment like air conditioners or move them away from the unit.
To Next Page
General
