Do you have a question about the Yamaha RX-V461DAB and is the answer not in the manual?
Channels | 5.1 |
---|---|
Total Harmonic Distortion (THD) | 0.06% |
Frequency Response | 10 Hz - 100 kHz |
DAB Tuner | Yes |
Speaker load impedance | 6 ohms |
Surround sound formats | Dolby Digital, DTS |
Total Harmonic Distortion Details | 0.06% at 1 kHz |
Input Sensitivity/Impedance | 200 mV / 47 k ohms |
Signal-to-Noise Ratio | 100 dB |
FM Tuner | Yes |
AM Tuner | Yes |
Remote Control | Yes |
Inputs | 4 x RCA |
Outputs | Subwoofer output |
Tuning range | FM: 87.5 - 108 MHz, AM: 531 - 1602 kHz |
Dimensions (W x H x D) | 435 x 151 x 363 mm |
Speaker Terminals | 5-way binding posts |
Information on components with special characteristics requiring exact replacement.
Procedure to verify proper insulation of exposed surfaces from supply circuits after service.
Details on the use of lead-free solder for PCB assembly and repair.
Schematic and panel diagrams for RAV315 and RAV310 remote controls.
Step-by-step instructions for removing the unit's top cover and front panel.
Procedures for removing HDMI, DAB, Video, and DSP Printed Circuit Boards.
General list of diagnostic menu items and their capabilities.
Diagnostic menus for protection functions and event history.
Diagnostic menus for soft switch settings and ROM version/checksum.
Details on ANALOG BYPASS and DSP BYPASS outputs for signal testing.
Procedure for checking audio signal output distribution.
Prevents back-up RAM initialization to protect user settings.
Reserves back-up RAM initialization for factory reset.
Diagrams showing pin connections for various components.
Layout and assignment of signals to grid positions.
Details of IC204-IC207 ports and their functions.
Details of IC401 ADC select port and related input tables.
Description of the 2/8-channel audio CODEC with DIR.
Description of the 8-channel electronic volume IC.
Description of the 18-digit 5x7 segment VFD controller/driver.
Block diagrams illustrating video, audio, and power supply interconnections.
Diagrams showing pin connections for various IC components.
List of diode types used in the circuit.
List of transistor types used in the circuit.
Layout diagram for the DSP Printed Circuit Board, Side A.
Layout diagram for the MAIN (1) Printed Circuit Board.
Layout diagrams for Operation (7) and (8) Printed Circuit Boards.
Layout diagrams for Operation (9) Printed Circuit Boards.
Layout diagrams for Operation (10) and (11) Printed Circuit Boards.
Detailed schematic diagrams for the DSP section.
Schematic diagram of the unit's power supply section.
List of electrical components with part numbers and descriptions.
Schematic and panel diagrams for RAV315 and RAV310 remote controls.
Diagram showing the layout and numbering of remote control keys.
Function to reset all unit parameters to initial factory settings.