En 1
This document explains how to connect the unit to a wireless network.
Attaching the wireless antenna
Attach the supplied wireless antenna to the unit.
Be sure to turn off the unit before attaching the antenna.
• Do not apply excessive force on the antenna. Doing so may damage the antenna.
• When attaching the antenna, hold the root of the antenna and screw it into the WIRELESS jack tightly.
• The antenna can be bent in only one direction. Check the orientation of the joint and bend the antenna in
the proper direction.
• Do not connect the antenna other than the supplied one.
• When packing the unit, remove the antenna to prevent damage.
Connecting the unit to a wireless network
Connect the unit to a wireless router (access point).
There are several methods to connect the unit to a wireless network. This section
describes the following three methods.
• Manual configuration is also available. For details, see “Connecting to a network wirelessly” on the Owner’s
Manual.
Wireless network connection guide
WIRELESS
WIRELESS
WIRELESS
Screw in
Bend
Turn clockwise to the vertical position
Joint
A: Using the WPS button configuration
Set up a wireless connection with the WPS button on the wireless router
(access point).
C: Searching for an access point
Set up a wireless connection by searching available access points.
B: Sharing the iOS device setting
Set up a wireless connection by applying the connection settings on iOS
devices (iPhone/iPod touch*).
* You need iOS devices with iOS 5.0 or later.
UCAB
English
To Next Page
Need help?
General
Weight and Dimensions
