To Next PageTo Next Page
Need help?Do you have a question about the Yamaha RX-V595 and is the answer not in the manual?
General| Type | AV Receiver |
|---|---|
| Channels | 5.1 |
| Power Output Condition | 8 Ohms, 20 Hz - 20 kHz, 0.06% THD |
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion (THD) | 0.06% |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Surround Sound | Dolby Digital, DTS |
| Digital Inputs | Optical, Coaxial |
| Video Outputs | Composite |
| Analog Inputs | 5 x RCA |
| Dimensions (W x H x D) | 435 x 151 x 363 mm |
Lists 18 safety and operational warnings for safe use and maintenance of the unit.
Provides essential warnings and advice before operating the unit, including installation and usage guidelines.
Explains the use of DSP to create theater-like audio environments by processing sound fields.
Describes the Dolby Pro Logic decoder for realistic Dolby Surround movie theater sound in the home.
Introduces Dolby Digital technology for advanced multi-channel audio experiences in home theater systems.
Details controls for power, source selection, tuning mode, and band selection on the front panel.
Explains optimal speaker setups, including 5-speaker and 4-speaker configurations.
Illustrates connections for various audio and video components to the rear panel terminals.
Explains connecting speaker systems (A or B) to the main, rear, and center terminals.
Explains how to set the impedance selector based on speaker impedance and configuration.
Explains settings for the center speaker output (LARGE, SMALL, NONE) and bass redirection.
Details settings for rear speakers (LARGE, SMALL) and bass redirection to subwoofer.
Explains settings for main speakers (LARGE, SMALL) and bass redirection options.
Covers settings for bass and LFE output distribution to main speakers or subwoofer.
Explains setting up the unit to use the test tone generator for speaker balance adjustment.
Details using test tones to adjust main and center speaker output levels.
Explains fine-tuning center and rear speaker levels and cancelling the test tone.
Guides on turning the unit on, setting volume, and selecting the desired input source.
Explains how to select and control various connected components using the remote's selector dial.
Explains the procedure for programming the remote to control other manufacturer's components.
Addresses common problems like unit not turning on, not working, or no sound/picture.
Covers issues related to FM reception, tuning, remote control malfunction, and sound degradation.
