Yamaha RX-V670 User Manual (English)

Other manuals for Yamaha RX-V670

Questions and Answers:

J
Jose StewartAug 20, 2025
What to do if my Yamaha RX-V670 has no sound or picture?
- K
  Krystal Zamora MDAug 20, 2025
  If your Yamaha Stereo Receiver isn't producing sound or picture, check the output cord connections to ensure they are properly connected. If the issue continues, the cords may be defective. Also, verify that the MUTING switch is OFF by first turning the volume control to the left, then using the remote to switch the MUTING off, and adjusting the volume. Finally, ensure the appropriate input selector is pressed for your input source.
J
joseph75Aug 22, 2025
Why does the sound suddenly go off on my Yamaha Stereo Receiver?
- B
  Barbara BlackAug 22, 2025
  If the sound on your Yamaha Stereo Receiver suddenly cuts out, the protection circuit may have been activated due to a short circuit or similar issue. To reset it, turn the unit off and then back on.
A
amandaduffyAug 25, 2025
Why is there no sound from the rear speakers on my Yamaha RX-V670 Stereo Receiver?
- C
  Christian BenjaminAug 25, 2025
  If there is no sound coming from the rear speakers of your Yamaha Stereo Receiver, first check that the sound output level of the rear speakers is not set to 0. If it is, turn up the sound output level using the REAR LEVEL key. Also, if you are playing a monaural sound source in DOLBY PRO LOGIC or ENHANCED mode, try selecting another program suitable for the monaural sound source.
K
Katherine MoralesAug 26, 2025
Why is there no sound from the center speaker on my Yamaha RX-V670 Stereo Receiver?
- J
  Jason KingAug 27, 2025
  If there is no sound coming from the center speaker on your Yamaha Stereo Receiver, first check that the sound output level of the center speaker is not set to 0. If it is, turn up the sound output level using the CENTER LEVEL key. Also, check that the center mode is not in PHANTOM mode, select NORMAL or WIDE. Finally, ensure that you have selected the appropriate sound field program.
S
Sharon StewartAug 28, 2025
What to do if my Yamaha RX-V670 fails to turn on?
- D
  David WhiteheadAug 28, 2025
  If your Yamaha Stereo Receiver fails to turn on when you press the power switch, make sure the power cord is fully and firmly plugged into the outlet.
K
kwatsonAug 29, 2025
Why is FM stereo reception noisy on my Yamaha RX-V670?
- J
  Jenna GambleAug 30, 2025
  Noisy FM stereo reception on your Yamaha Stereo Receiver may occur if the transmitter is too far away or the antenna input is poor. Check the antenna connections and consider using a multiple element FM antenna to improve reception.
J
Joshua AtkinsAug 31, 2025
What to do if my Yamaha RX-V670 remote control transmitter does not work?
- A
  Alexis SpenceAug 31, 2025
  If the remote control transmitter for your Yamaha Stereo Receiver isn't working, it may be due to direct sunlight or strong lighting (like an inverter-type fluorescent lamp) hitting the remote control sensor on the main unit. Try changing the position of the main unit to avoid this interference.
E
Elizabeth OwensSep 2, 2025
Why does my Yamaha RX-V670 Stereo Receiver only output sound from one speaker?
- W
  William RoachSep 2, 2025
  If your Yamaha Stereo Receiver is only outputting sound from one speaker, check the BALANCE control to ensure it is set correctly. Also, verify that the speaker cord connections are correct and secure. If the problem continues, the cables may be defective.
A
Anne JohnsonSep 4, 2025
How to fix sound humming on Yamaha RX-V670 Stereo Receiver?
- M
  Michael WatkinsSep 4, 2025
  If your Yamaha Stereo Receiver is producing a humming sound, ensure the audio plugs are firmly connected. If the hum persists, the cord may be defective. Also, if you're using a turntable, make sure it is properly connected to the GND terminal on the unit.
E
Ellen BurkeSep 6, 2025
What to do if I can't tune a desired station with Auto tuning on my Yamaha RX-V670 Stereo Receiver?
- L
  Luis FloresSep 6, 2025
  If you cannot tune in a desired station using Auto tuning on your Yamaha Stereo Receiver, it may be because the station's signal is too weak. Try using Manual tuning mode. For FM stations, consider using a high-quality directional FM antenna. For AM stations, tighten the AM loop antenna connections and rotate it for the best reception.

Yamaha RX-V670 Specifications

General

Power Output	100 W per channel (8 ohms, 20 Hz - 20 kHz, 0.06% THD)
Channels	7.2
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
HDMI Inputs	6
Weight	22.5 kg
Response Bandwidth	10 Hz - 100 kHz
Input Impedance	47 kOhm
Preset Station Qty	40
HDMI Switching	Yes
3D Technology	Yes
Tuner Bands	AM, FM
Speaker Impedance	8 ohms
FM Sensitivity	1.0 µV
Amplifier Output Details	90 W per channel (8 ohms, 20 Hz-20 kHz, 0.09% THD)
Tuner Type	FM/AM