50
■ DESIGNATING A CHORD ROOT AND TYPE - After selecting the measure
and specifying the clock, press [2] twice to position the flashing cursor
over the Chord Root, and press [-1] and [+1] to select the Chord Root.
Next, press [1] once to position the flashing cursor over the Chord Type,
and press [-1] and [+1] to select the Chord Type. Then press [ENTER].
Recorded chord data will be displayed as a black square at the specified
location.
■ DELETING A CHORD BY EVENT - Even after recording a song, you can go
back and delete an unwanted chord at any time at a specific event
location, or clock position. First, in Song Record Mode, press [CHORD] to
access Chord Assign. Next, locate the measure containing the chord you
want to delete, by pressing [FWD] and [BWD]. Then, move the cursor to
the beat/clock position and press [+1] or [-1] to locate a specific
beat/clock position. (A small black square will display beneath a clock
position where chord change data exists.) Finally, hold [DELETE] and
press [ENTER] to delete the chord data.
MODES&FUN.QX99.11.176:02PMページ50
To Next Page
Loading...
