Yamaha TX-10 - Exchanging Preset Stations

11
English
1 Recall the preset station on E1 (by following the method
of “To recall a preset station” on page 9).
2
3 Next, recall the preset station on A5 by following the
same method with step 1.
4
Shows the exchange of stations is completed.
EXCHANGING PRESET STATIONS
You can exchange the places of two preset stations with each other as shown below.
Example)
If you want to shift the preset station on E1 to A5, and vice
versa.
Flashes
Flashes
ENTER/
KEY MODE
MEMO
<General model only>
<U.K. and Europe
models only
>
2 4
<U.K. and Europe models><General model>
ENTER
KEY MODE
PS/PTY/SEEK
SHIFT/
EDIT
<General model only>
<U.K. and Europe
models only
>
EDIT
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is set off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If so,
it can be re-programmed by simply following the PRESET
TUNING steps.
2 4
Press and hold for
about 3 seconds.