Yamaha YSP-5600 Firmware Update Manual

YSP-5600 Firmware Update Procedure Manual
1. Introduction
This document is firmware update procedure manual for YSP-5600 using USB package.
2. Procedure
1. Unplug the cable of YSP-5600
2. Put USB package for YSP-5600 in USB flash memory
3. Connect USB flash memory to YSP-5600
4. Press-and-hold “volume -“ button and plug in the cable
5. “FW Update” indication is appeared on FL
6. Wait for firmware updating process is finished
7. If “Success!” was displayed on FL, the firmware updating was completed. Please power off
YSP-5600. If some error was occurred, please check the meaning of the error referencing “3.
Indication and Meaning”.
3. Indication and Meaning
Some informations are displayed on FL. The following table is informations and meanings.
Page  of 1 3
Note : If some progress was stopped more than 3 minutes, some problem might be occurred.
Please power off YSP-5600 and try again.

Yamaha YSP-5600 Specifications

General

Audio decoders	DTS 96/24, DTS Digital Surround, DTS-ES, DTS-HD HR, DTS-HD Master Audio, Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD
Equalizer modes	Jazz
RMS rated power	128 W
Audio output channels	7.1 channels
Movie modes	Action, Science Fiction
Docking connector type	-
Apple docking compatibility	Yes
Product color	Black
Soundbar speaker RMS power	88 W
HDMI in	4
Bluetooth version	2.1+EDR
HDMI ports quantity	5
Number of HDMI outputs	1
Connectivity technology	Wired & Wireless
Power consumption (standby)	0.3 W
Power consumption (typical)	68 W

Weight and Dimensions

Depth	93 mm
Width	1100 mm
Height	212 mm
Soundbar weight	11340 g
Subwoofer depth	- mm
Subwoofer width	114.3 mm