4. OPERATION PROCEDURE
Example 1.
Auto Start mode set to timer:
Operation automatically begins 35 hours and 30
minutes after is pressed.
Example 2.
Auto Start mode set to clock:
Press and operation begins automatically at
15:00 (3:00PM).
1) Press to enter standby mode (wait) until
operation begins at the selected time.
2) The OPERATE lamp flashes and lower display
will show remaining time until start or time at
which operation will start.
Upper display shows current chamber
temperature, while lower shows remaining wait
duration or operation start time. When timer is
selected, a countdown to operation begins:
Temperature setting may be confirmed by
pressing :
Press once more to go back to viewing
remaining wait duration.
To Next Page
Loading...
