Yamato DF412/612 - Copying & Deleting Programs

31
4. OPERATION PROCEDURE
Programming Procedure
The following outlines the procedure for building the example program on P.30:
(This procedure assumes unit is set to factory defaults)
Screen status
Procedure
I.
II.
flashes.
III.
PROGRAM lamp flashes.
- “ ” appearing in upper display
indicates that steps for selected program
have already been entered and finalized.
- Last “ ” in flashes.
- First “ ” in
flashes.
- Changes “ ” to “ ”.
1-1
Enter program pattern , .
“ ” in flashes and upper display shows
“ ”, signifying that program steps have
not yet been entered.