64
11. ACCESSORY OPTIONS
Accessory Item List
Button to shut main power off in the event
of an emergency.
Integrated into main unit.
Paperless (inputs: 6), sensor optional (may
be used with ODT48). The following three
parameters may be monitored: temperature
as measured by unit main controller (PV),
objective temperature while in operation
(SV), heater output ratio (MV).
8m substitution power cable for main unit.
No plug included.
Electronic damper allowing exhaust port
aperture and air flow to be controlled
automatically by motor and control circuit in
five stages.
Upward facing
exhaust duct
flange w/heat
shield
Duct directs exhaust emissions up and out.
Optional exhaust port flange (ODF46) is
required with this option.
Rear-facing
exhaust duct
flange
Flange for connecting exhaust port exhaust
duct ODH34 (O.D. :φ80mm).
Installed on back of unit.
Additional
Cable Port
(φ25mm)
Cable ports of different inner diameters
may be installed in in left and right panels.
confirm position and number of required
ports before placing order.
Additional
Cable Port
(φ50mm)