To Next PageTo Next PageWhat to do if Yamato Scales will not turn on?
If your Yamato Scales won't turn on, the batteries might be dead, or the AC/DC adapter may not be properly connected. Try replacing all four batteries with fresh ones. Also, check that the adapter is correctly connected to the scale and plugged into a working outlet.
What to do if Yamato PPC-300 Scales shows load over allowable limit at start up?
If your Yamato Scales indicates a load exceeding the allowable limit upon startup, remove all items from the scale platform and then press the key.
What to do if Yamato Scales shows low battery?
If your Yamato Scales indicates low batteries, replace all four batteries with fresh ones.
What to do if Yamato PPC-300 shuts off due to exhausted batteries?
If your Yamato Scales shuts off because of exhausted batteries, replace all four batteries with fresh ones.
What to do if Yamato PPC-300 Scales shows load under allowable limit at start up?
If your Yamato Scales shows a load under the allowable limit at start up, remove any items that might be wedged underneath the scale platform, then press the key.
What to do if Yamato PPC-300 attempted to zero a load greater than allowed?
If you've attempted to zero a load greater than allowed on your Yamato Scales, remove all items from the scale platform and press the key.
What to do if I zeroed Yamato Scales with a load on the platform, and then removed the load?
If you zeroed your Yamato Scales with a load on the platform and then removed the load, remove all items from the scale platform and press the key.
What to do if my Yamato PPC-300 will not turn on?
If your Yamato Scales won't turn on, first ensure that the batteries are installed with the correct polarity. If they are, try replacing all four batteries with fresh ones. Also, check that the adapter is properly connected to both the scale and a working power outlet.
How to fix low battery on Yamato PPC-300?
If your Yamato Scales show a low battery warning, replace all four batteries with fresh ones.
What to do if Yamato PPC-300 show load over limit at start up?
If your Yamato Scales show a load over the allowable limit at start up, remove all items from the scale platform and press the key. If the issue persists, power the scale off and back on. If problems continue, calibrate the scale.
General
