What to do if the Yanmar 1GM10 Engine oil low pressure alarm indicator lights?
If the engine oil low pressure alarm activates, it could be due to a low engine oil level. Check the engine oil level and add or replace oil as needed. Alternatively, the engine oil filter might be clogged. In this case, replace the engine oil filter and change the engine oil.
Why does Yanmar 1GM10 Engine produce black smoke?
If your Yanmar Engine is producing black smoke, it may be due to increased load (inspect propeller), a contaminated intake silencer (clean element), improper fuel (replace with recommended fuel), faulty spraying of the fuel injection valve, or incorrect intake/exhaust valve head clearance.
What to do if Yanmar 1GM10 starter turns, but engine does not start?
If the starter turns but your Yanmar Engine won't start, possible causes include: - No fuel: Replenish fuel and vent air. - Clogged fuel filter: Replace the filter element. - Improper fuel: Replace with recommended fuel. - Other issues: Faulty fuel injection or compression leakage from the intake/exhaust valve may also be responsible.
Why does the charge lamp not go out during Yanmar 1GM10 Engine operation?
If the charge lamp on your Yanmar Engine stays on during operation, it could be due to a loose or broken V-belt (replace or adjust tension), a defective battery (check fluid level and specific gravity, then replace if needed), or alternator power generator failure.
What to do if Eng.Lube Oil Press. Warning Lamp goes on in Yanmar Engine?
If the Engine Lube Oil Pressure Warning Lamp goes on for your Yanmar Engine, it could be caused by insufficient lube oil or a clogged fuel filter. Check the lube oil level and replenish or replace as needed.
Why Yanmar 1GM10 starter does not turn or turns slowly?
If the starter on your Yanmar Engine doesn't turn or turns slowly but the engine can be turned manually, the issue might be due to a faulty clutch position (shift to NEUTRAL and start), insufficient battery charge (check fluid level, recharge or replace), cable terminal contact failure (remove rust from terminal and retighten), a faulty safety switch device, a faulty starter switch, or power lacking due to other use.
What to do if Alarm Buzzer and Alarm Lamps On During Yanmar 1GM10 operation?
If the alarm buzzer and alarm lamps are on during Yanmar Engine operation, immediately shift to low speed, check which lamp is illuminated, and stop the engine for inspection. If no abnormality is found and operation seems normal, return to port at your lowest speed and request repairs.
What happens if Yanmar 1GM10 has faulty warning devices?
Do not operate the Yanmar Engine if the alarm devices are not repaired. Serious accidents may occur if difficulties are not spotted due to faulty alarm lamps. If the alarm buzzer does not sound when the switch is turned ON, the circuit may be broken, or the buzzer may be defective.
General| Number of Cylinders | 1 |
|---|---|
| Combustion System | Direct injection |
| Starting System | Electric start |
| Rated Output | 6.6 kW (9 hp) at 3600 rpm |
| Lubrication System | Forced lubricating |
| Engine Type | Vertical, water-cooled, 4-cycle diesel |
To Next Page
