Why is the exhaust color not normal on my Yanmar Engine?
If the Yanmar Engine exhaust color is poor, it could be due to neglecting to race the engine. When operating the engine at low speed for extended periods, race the engine once every two hours by accelerating from low to high speed about five times with the clutch in NEUTRAL.
Why is my Yanmar 3YM20 having trouble starting?
If you're having trouble starting your Yanmar Engine, it could be due to a few reasons. First, make sure fuel oil is being injected by priming well. Also, check if the pinion or ring gears do not mesh, and if so, tighten them. Finally, ensure there is sufficient fuel oil in the tank by adding fuel.
How to fix Yanmar Engine low oil pressure light?
If the engine oil low pressure alarm indicator light is on, it could be due to a low engine oil level. Check the engine oil level and add or replace oil as needed. Another potential cause is a clogged engine oil filter. If this is the case, replace the engine oil filter and the engine oil.
What to do if Yanmar 3YM20 Engine starter turns but engine doesn't start?
If the starter turns but the Yanmar Engine doesn't start, possible causes include: no fuel (add fuel and bleed the fuel system), a clogged fuel filter (replace the filter element), or improper fuel (replace with recommended fuel). For problems with fuel injection or compression leakage, consult an authorized Yanmar Marine dealer or distributor.
What to do if my Yanmar Engine suddenly stops?
If your Yanmar Engine suddenly stops, it could be due to several reasons. Check if the fuel oil supply is cut off or if there's insufficient oil in the fuel oil tank; if so, add fuel oil and prime the engine. Air or water in the fuel oil system could also be the cause; bleed the air or remove water from the drain and fuel oil system, then prime. Ensure the fuel oil cock is open and the fuel oil filter isn't clogged—clean it if necessary. Damage to the fuel oil system, a problem with the fuel feeding pump, or governor trouble could also be responsible; check and make necessary repairs. If the governor spring is damaged, replace it. Clean the governor sleeve if it's sticking. Finally, check for seizure of moving parts and repair as needed.
What should I do if an alarm sounds during Yanmar 3YM20 operation?
If an alarm sounds during Yanmar Engine operation, immediately reduce the engine speed, check the warning lamps, and stop the engine to perform necessary repairs.
What to do if sufficient water is not being discharged from the Yanmar Engine seawater outlet pipe?
If insufficient water is being discharged from the seawater outlet pipe of your Yanmar Engine, stop the engine immediately. Identify the cause of the low discharge and perform the necessary repairs.
What to do if Yanmar 3YM20 Engine water in sail drive seal indicator lights are on?
If the water in sail drive seal indicator light is illuminated, it suggests the rubber sail drive seal is broken. In this case, it's recommended to consult an authorized Yanmar Marine dealer or distributor.
What to do if my Yanmar 3YM20 has poor exhaust color?
If your Yanmar Engine has poor exhaust color, it could be due to a faulty fuel injection pump or valve. Check, repair, or replace the fuel injection pump. Try cleaning the fuel injection valve. You can also replace parts or adjust the settings.
Why Yanmar Engine battery light stays on?
If the battery low charge indicator on your Yanmar Engine remains lit during operation, the V-ribbed belt may be loose or broken; replace it or adjust its tension. Alternatively, the battery itself may be defective, so check the battery fluid level and specific gravity, or replace the battery. If these steps don't resolve the issue, there may be an alternator power generation failure, which requires consulting an authorized Yanmar Marine dealer or distributor.
General| Engine Model | 3YM20 |
|---|---|
| Number of Cylinders | 3 |
| Aspiration | Natural |
| Combustion System | Direct injection |
| Compression Ratio | 23:1 |
| Fuel System | Mechanical injection |
| Engine Type | Vertical, water-cooled 4-cycle diesel engine |
| Displacement | 0.854 L |
| Max Output | 21 hp (15.3 kW) / 3600 rpm |
| Cooling System | Fresh water cooling |
| Lubrication System | Forced lubricating by trochoid pump |
| Starting System | Electric starter |
| Alternator | 12V |
The primary manual for operating Yanmar marine engines.
Details of the EPA emission control system warranty for Yanmar engines.
Specifications, handling, and precautions for diesel fuel.
Specifications, handling, and checking procedures for engine oil.
Step-by-step guide on how to start the Yanmar engine safely.
Summary of maintenance items based on operating hours and time intervals.
Safety warnings before undertaking any troubleshooting procedures.
Checks to perform immediately after starting the engine to identify issues.
A guide linking engine symptoms to probable causes and measures.
Detailed specifications for 2YM15, 3YM20, 3YM30E, and 3YM30 engines.
Warranty details for the emission control system in the USA.
Warranty information for non-road emission systems.
To Next Page
