Driving
40
2. Starting and stopping the engine
● Low-speed drive, and start rapidly or
neither rapid turn nor never stop
rapidly.
● Do not high-speed drive in the road
where a lot of slopes, ruggedness, and
curves exist.
● When starting, it signals to
surroundings, and it starts while
confirming safety slowly.
● When being working and moving, the
helmet is worn for safety.
Starting the engine
1- Put the main shift lever and range shift lever to “N”.
2- Pull the threshing clutch lever and header clutch
lever to “OFF”.
The engine cannot be started up if the two levers
are set in the “ON” position.
3- Set the accelerator lever to “Low”.
4- Step the brake pedal to the floor, and pull the key
switch to “Start”.
The safety switch will not work and the engine can
not be started up if the brake pedal is not stepped
to the floor.
Main shift lever
Range shift lever
Header clutch lever
Threshing
clutch lever
OFF
ccelerator lever
https://tractormanualz.com/yanmar/
To Next Page
Loading...