Periodic Inspection
72
1. Schedule for refueling, oiling and water supply
[IMPORTANT]
When changing or adding oil, after filling a predetermined amount of oil and running the engine for a few
minutes, check that the oil is within the range of oil gauge again.
If it is exceeding the oil gauge, either add or release oil
[Precaution]
Replace oil while periodic inspection. (Use the designated oil)
Never drain the waste oil directly into a river or sewer, but employ a professional agent for treatment.
ALWAYS BE ENVIRONMENTALLY RESPONSIBLE
● Follow the guidelines of the governmental agency for the proper disposal of
hazardous materials such as engine oil, diesel fuel, engine coolant and, machine
fluid, grease.
● NEVER dispose of hazardous materials irresponsibly by dumping them into a sewer,
on the ground, or into groundwater or waterways.
● Failure to follow these procedures may seriously harm the environment.
● Comply with legal regulations and guidelines for disposal of: empty containers for
fuel, cooling water (coolant), oil, grease; fuel/oil filters; batteries; machine itself;
machine accessories; and packaging materials.
Item Capacity Type Interval
Fuel 80L Diesel fuel Before and after operation
Cooling
water
Main water tank 7.2L
Pure water, anti-freezing liquid
Or long life coolant
Every year
Aux. water tank 1.1L
Engine oil 10.2L Engine oil 15W-40 CD
First time: 50 hours
2nd time : 200 hours
After : every 200 hours
Transmission oil 8.5L
TF300 transmission oil
(*TF500 recommended)
First time: 50 hours
2nd time : 400 hours
After : every 400 hours
Rotor drive case 1.4L 90# gear oil
First time: 50 hours
2nd time : 400 hours
After : every 400 hours
Hydraulic oil tank
(about 3L in the pipe)
17L
Wear-resistant hydraulic oil
VG46 or VG56
Every 400 hours
https://tractormanualz.com/yanmar/
To Next Page
Loading...