Trouble shootin
97
In the event that mechanical condition becomes worse, turn off the engine and engage the
brake pedal lock firstly, and then perform trouble shooting as instructed below to prevent
accidents. Contact the dealer if you could not handle a failure.
1. Engine section
Condition Check Remedy
Starter motor does
not work when the
key switch is
turned to “Start”
Brake pedal stepped?
Put the key switch to “Start” after stepping the brake
pedal to the floor
Threshing clutch lever in “ON” position? Put the lever to “OFF”
Dead battery? Recharge the battery
Battery terminals loosened or corroded?
Clean the terminals and apply antirust oil on them after
tightening
Fuse blown? Replace the fuse
Starter motor
rotates, but the
engine can not be
started
Does the fuel pump work?
(Blown fuse or faulty fuel pump)
Replace the fuel pump
Any fuel in the fuel tank? Refuel
Fuel pipe damaged? Replace the fuel pipe
Air mixed in fuel? Exhaust air
Range shift lever in the “N” (neutral) position? Put the lever to “N”
Water leaking into the fuel tank?
Drain water accumulated in the fuel filter or water
separator
Is the pipe blocked after the fuel tank is
contaminated?
Clean the fuel tank and pipe
Engine stops
unexpectedly
during operation
Any fuel? Refuel
https://tractormanualz.com/yanmar/
To Next Page
Loading...