Yanmar AW82V - Replacing HST Filter and Hydraulic Oil; Checking and Replacing Cooling Water

Periodic Inspection
75
* Be sure to wait till the engine becomes cool before
checking the oil level.
* It will be easier to drain oil if you remove the oil port
cover.
[Precaution]
 Keep the machine on a horizontal level ground.
 Raise the header to the highest position and fix
the safety lock.
 Gears and bearing in the transmission and the
case may be damaged if transmission oil is not
replaced as scheduled.
 The transmission should be disassembled and
checked every 1000 service hours of the
machine.
Other parts
Add oil to the specified level through the oil port.
Recommended
oil
Replacing
interval
Standard
level
Rotor
drive case
Gear oil 90#
First time:
50 hours
2nd time :
400 hours
After: every
400 hours
1.4L
Hydraulic
oil tank
(about 3L
in the
pipe)
Hydraulic oil
VG46 orVG56
Every 400
hours
17L
Rotor drive case
Hydraulic oil tank
Oil
p
ort
Drain bolt
Uppe
r
Lowe
r
Drain bolt
https://tractormanualz.com/yanmar/