32
Front Axle Assembly (YM155, YM135)
(1)
lnsert the (22) ball bearing 6204, (16) ball
bearing 6205,
(15) circlip 48, and the (14) oil
seal
TC
355211
into the (17) front wheel hub.
(2)
lnsert the
(13) king pin complete into the
(17) front wheel hub (step
1).
(3)
Attach
a
(18) plain washer to the front
wheel hub (step
2). and fasten with
a
(19) castle
nut.
(4)
To prevent the (19) castle nut from loosen-
ing
,
insert
a
(21) cotter pin 4
x
40.
(5) lnsert the
(8)
bushing, (10) ball bearing
(11)circlip 48, and (12) oil seal into the (9) front
axle.
(6)
lnsert the (17) front wheel hub (step 1-4)
into the
(9) front axle (step 5).
,--.
(7)
To the front axle assembly (step
6)
insert
the (7)
"0
ring 1A-2025, (6) king pin upper
cover, (5) feather key, (4) knuckle arm,
(3) plain
washer, and (2) spring washer
18. Tighten the
(1)
nut 18.
(8)
Attach the (23) grease nipple, and (24) bolt
6 x 4.5.
NOTES:
a]
Put
in the (14) oil seal
TC
355211 so it is
flush with the front edge of the case.
b)
Be sure to pur in enough grease in the
(9)
front
axle,
/I
7) front wheel hub, (20) front wheel hub
cover, and the ball bearings.
c)
Be sure to loosen the /24) bolt 6
x
4.5 when
purring in grease through the
123) grease nipple.
d) Tightening torque:
/I) nut 8: 116-137 ft-lbs 116-19 kg-m)
(19)
castle nut 20: 58-87 ft-lbs /8-12 kg-m)
(26) bolt 12x 25 (4 pcs): 58-72 ft-lbs 18-10 kg-
mi
e)
Be sure not ro damage the (8) bushing when
press fitting.
f)
Insert the /I21 oil seal so
it
comes in contact
with
the /I11 circlip 48.
To Next Page
Loading...
