Operating the engine
27
8)
Turn decompression lever as shown below
and depress clutch pedal to close starter
safetv switch.
9)
Turn key clockwise against spring pressure
to engage saner. When
starter gives enough
rotation to start engine, release decompres-
sion lever.
Release key immediately when engine starts.
Do not operate starter more than
10
seconds at a
time.
If
engine does not start, wait at least one
minite before trying again.
10) Check indicator lamps as soon as engine
starts.
If
lamps do not go out, stop the
engine and determin the cause.
Always leave key
turned
on. in position
"ON",
while engine running.
11) Operate engine at approximately 1500 rpm
for five minutes. Do not accelerate or apply
a
load until engine warms up.
To Next Page
Loading...
