Yanmar YM240 - Turning, Slopes, Uphill, and Downhill Driving

32 Operating the tractor
To set parking brake, pull lever back and firmly
depress brake pedals.
To release parking brake, push lever forward while
depressing brake pedals.
(6) Starting the tractor
Release clutch pedal slowly to prevent front wheel
lifting when starting the tractor.
It is particularly
important for transporting heavy implement.
1) Make sure both brake pedals are connected
together.
2) Set engine speed about 1500rpm
3) Raise implement by using hydraulic control
lever
ii it is equipped.
4) Depress the clutch pedal fully
/
6) Release clutch pedal slowly to engage the
clutch.
7) Adjust travel speed by throttle lever.
(7) Stopping the tractor
--
When parking unavoidably on slopes, chock both
rear and front wheels.
1) Pull throttle lever back to slow idle position.
2) Depressclutch pedal quickly.
3) Depress both brake pedals
4) Place gear shift lever and range shift lever in
"NEUTRAL" position.
5) Ground all attachments.
6) Pull parking brake lever back and firmly
depress brake pedals.
,-
Lock
7) Pull throttle lever to stop position.
8) Turn key switch off and remove key before
leaving the tractor.
5) Place gear shift lever and range shift lever in
the desired positions.