Safety
Instructions
5
13. When using a heavy implement on 3point
hitch, always install front ballast for stability
and steering control.
14.
Too large an implement
is
dangerous for
tractor operation.
Refer to your implement
operator's manual for minimum and maximum
horsepower requirement.
15. Do not pull carts etc. from the top link or top
link hinge, the rear axle or any point above the
drawbar. Doing so could cause the tractor tip
over rearward. For pulling, attach carts etc. to
the
drawbar only.
Use care when pulling loads or using heavy
implement.
1) Use only approved hitch points.
2) Limit loads to those you can safely control.
3) Don't turn too sharp, and care when back-
ing.
4)
Use counterweight or wheel weights when
suggested in operator's manual.
16. Take all
possible precautions as follows when
leaving tractor unattended:
a) Disengage PTO.
b)
Lower implement to ground.
C)
Shift all shift levers to neutral.
dl Latch power shift lock lever. (Power shift
transmission only)
e) Couple brake pedals together and set park-
ing brake
lever.
f)
Run engine to cool for 2 to 3 minutes at
onethird throttle speed and no load.
g) Stop engine.
h) Cycle hydraulic controls to eliminate
residual pressure.
il
Remove key.
When you leave operator's seat, wait for engine
and implement parts to stop moving.
17.
Do not permit any person other than operator
to ride or board on tractor or implements
including wagons.
Never allow children in .the tractor
cab
or allow
them to ride on your lap.
Nwer allow anyone to stand on the overhead
guard or fenders.
Do not "cowboy" or play
games with a tractor.
To Next Page
Loading...
