YARD Commander YTL-590-043 Use And Care Guide

6
Please contact 1-888-723-6534 for further assistance.
Assembly
1
Attach the Axle Support
and remove the two M6 wing nuts (X) on the wheel axle
supports. Fold the wheel axle supports in towards each
other. Then reinstall the M6 wing nuts (X) to the bottom
assembly (A).
2
Attach Tongue Support
CAUTION: Pay attention to the orientation of the hole during
assembly. The hole on tongue support (K) should be on the right
side.
Attach the tongue support (K) to the back of the bottom panel (A).
Pay attention to the orientation of the hole on the tongue support.
The hole should be oriented as shown below. Install four sets of
M6x16 screws (AA), Ø6 lock washers (BB) and M6 hex nuts (CC).
Hardware can be tightened later when cart is turned upright.
Hardware Used
x 2M6 Wing Nut
X
X
K
AA
BB
CC
Hardware Used
AA x 4M6x16 Screw
x 4Ø6 Lock WasherBB
x 4M6 Hex NutCC
X
X
A
A
Lay down the bottom panel assembly (A) on a at surface,

YARD Commander YTL-590-043 Specifications

General

Brand	YARD Commander
Model	YTL-590-043
Category	Outdoor Cart
Language	English