15
OPERATION
To clear a ooded engine
NOTE! If the engine won’t start after you have tried several times, the engine may be
ooded with excess fuel . Use following procedure to clear the engine.
1. Move the throttle lever to the stop position.
2. Remove the spark plug, dry it, wait 5 minutes and then reinstall it.
NOTE! Install the spark plug carefully by hand to avoid cross-threading. After the plug is
seated tighten 1/8 to 1/4 turn with a spark plug spanner to compress the washer.
3. Move the throttle lever to the rabbit position.
4. Repeat the starting procedure.
Mowing
WARNING! Always observe the strictest safety procedures when using the lawn
mower. Carefully read the safety instructions of this manual before using the lawn
mower.
WARNING! Never open the rear ap, remove or replace the grass catcher whist the
engine is running.
1. Select your required cutting height.
2. Start the engine and allow it to warm up. See “To start the engine”.
3. To start cutting the grass push the lawn mower using the upper handle.
Fig. 14
STOP
To stop the engine
As shown in Fig. 14
Move the throttle lever to the stop position.
To Next Page
Loading...
