17
OPERATION
To stop the engine
As shown in Fig 15
Move the throttle lever to the stop position.
Fig. 15
To clean a flooded engine
NOTE! If the engine won’t start after you have operated the starterseveral times,
the engine may be ood with excess fuel . Use following procedure to clear and
start a ooded engine.
1. Move the throttle lever to the stop position to stop engine.
2. Remove the spark plug, dry it, and then reinstall it.
NOTE!Install the spark plug carefully by hand, to avoid cross-threading. After
the plug is seated tighten 1/8 to 1/4 turn with socket spanner of spark plug to
compress the washer.
3. Move the throttle lever to the rabbit position.
4. Operate the starter as described above.
Mowing
WARNING! Always observe the strictest safety procedures when using the
lawnmower. Carefully read the safety instructions of this manual before using the
lawnmower.
WARNING! Never open the ejector ap when the grass bag has been detached
(to be emptied)and the engine is still running. The rotating blade can cause
serious injuries!
STOP
To Next Page
Loading...
Need help?
General
