14
Hotline: 1-866-902-9690
OPERATION
START AND STOP THE ENGINE
WARNING: the blade begins to rotate as soon as the engine is started.
NOTE: Do not operate the lawn mower in enclosed or poorly-ventilated areas as the exhaust
gas contains toxic substances.
Keep hands, feet, hair and clothing away from the moving parts of the machine. The exhaust and
other parts of the machine will become hot during use.
Make sure that the blade is securely fastened before starting the engine.
NOTE: to start the engine, make sure that the spark plug cover is connected to the plug and the
machine is filled with sufficient oil and gas.
TO START THE ENGINE
1. When starting a cold engine, press down the primer fully 3-5 times (see Fig. 12).
WARNING! Too many presses on primer may cause engine flooding. When starting a warm engine,
the primer does not need to be used. If the engine stops due to a lack of gas, refill then press the
primer 3-5 times.
2. Stand behind the mower. Pull the Engine On/Off Control Bar toward upper handle with one hand and
place the other hand on the starter handle.
3. Pull the starter handle out approximately 4" to 6" (10 to 15 cm) until you feel a resistance and then start
the engine with a sharp pull (see Fig. 13).
NOTE: If the engine fails to start after three pulls, repeat the process.
Fig.12
Fig.13
primer
To Next Page
Loading...
Need help?
General
