To Next PageTo Next PageWhy does my Yard Machines Y25 Trimmer engine lack power or stall?
Your Yard Machines Trimmer might lack power or stall due to old or improperly mixed fuel; in this case, drain the fuel tank and add a fresh fuel mixture. Another possible reason is a fouled spark plug, which should be replaced or cleaned.
What to do if my Yard Machines Y25 engine will not accelerate?
If your Yard Machines Trimmer engine won't accelerate, the issue could be due to several reasons. Old or improperly mixed fuel is a common culprit, so drain the fuel tank and add a fresh fuel mixture. Also, the cutting head might be bound with grass; if so, stop the engine and clean the cutting head. Finally, check the air filter; a dirty air filter should be cleaned or replaced.
Why my Yard Machines Y25 Trimmer engine will not idle?
If your Yard Machines Trimmer engine won't idle, it could be due to a plugged air filter, which you should replace or clean. Another cause might be old or improperly mixed fuel, so drain the fuel tank and add a fresh fuel mixture. Finally, the carburetor adjustment might be improper; in that case, adjust it according to the Carburetor Adjustments section.
How to fix a Yard Machines Y25 cutting head that will not advance line?
If the cutting head on your Yard Machines Trimmer won't advance the line, try these steps: * Stop the engine and clean the cutting head if it's bound with grass. * Refill with a new line if the cutting head is out of line. * Rewind the inner reel if it's bound up. * Clean the inner reel and outer spool if the cutting head is dirty. * Disassemble, remove any welded sections, and rewind if the line is welded. * Disassemble and rewind the line if it was twisted when refilled. * Push the bump knob and pull out the line until 4 inches (102 mm) of line extends outside the cutting head if not enough line is exposed.
What causes a Yard Machines Trimmer cutting line to advance uncontrollably?
If the cutting line on your Yard Machines Trimmer advances uncontrollably, it is probably due to oil, cleaner, or lubricant in the cutting head. Clean and thoroughly dry the cutting head to resolve this issue.
General| Engine Type | 2-cycle |
|---|---|
| Engine Displacement | 25 cc |
| Cutting Width | 17 inches |
| Line Diameter | 0.095 inches |
| Cutting Swath | 17 inches |
| Starting System | Manual recoil |
Guidance on how to start and stop the trimmer engine.
A guide to diagnosing and fixing common issues.
Explanation of safety symbols, warnings, and their meanings.
Warning to wear protective gear against thrown objects and noise.
Warning against using E85 fuel due to potential engine damage.
Warning about severe injury from thrown objects and rotating parts.
Step-by-step guide for starting the trimmer engine.
Procedure for safely shutting down the trimmer.
Solutions for when the engine fails to start.
Troubleshooting steps for engine acceleration issues.
Diagnosing and fixing power loss or stalling.
