PART NO. 769-05304 P00 (11/09)
Quick Instructions to
Replace SplitLine
®
Trimmer Line
For replacement line, call
1-800-800-7310 or go to an
authorized service dealer.
For complete line installation,
refer to Line Replacement
replacement section of the
unit’s manual.
Quick Instructions
to Start Engine
for complete instructions, refer to the
Starting/ Stopping Instructions of the
unit’s manual.
Quick Instructions to
Assemble The Unit
for complete instructions, refer to the
Assembly Instructions of the unit’s
manual.
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
Read and understand all instruction, warning and danger labels on the unit.
Remove the cap from the
boom. Push the bottom add-on
into the coupler. Turn the knob
clockwise to tighten.
Put D-handle on shaft. Move
handle a minimum 6 inches
away from shaft grip. Insert
clamp bolt and tighten the
wing nut.
Push the cutting attachment shield
down to the top of the gearbox
assembly and rotate the shield to fit into
the recessed pocket. With all holes lined
up insert and tighten the screws to
secure the shield to the gearbox.
Tip unit so that the back of the engine
is facing up in a vertical position.
Remove the oil fill plug from the
crankcase and pour the entire bottle
of 4-cycle oil into the oil fill hole.
NOTE: Do not mix gas and oil
Fill fuel tank with fresh fuel.
Press primer bulb 10x and move
choke lever to Position 1.
Continue to squeeze
throttle control and
move the choke
lever to Position 3.
Move choke lever to
Position 2.
SQUEEZE and HOLD throttle
control for ALL further steps.
Pull the rope
5 times.
Continue squeezing the
throttle control and run unit for
additional 30 to 60 seconds to
complete warm up. The unit
may be used during this time.
Pull starter rope 3 to 5 times.
Making sure to keep throttle
squeezed, run unit for 30-60
seconds to warm up.
Crouch in starting
position.
DIDN’T START?
Repeat these instructions.
If unit still fails to start, refer
to the operator’s manual for
additional starting and
troubleshooting information
5 X
Unleaded
Gasoline
Choke Lever
Primer
Bulb
Choke Lever
Choke Lever
Using 10.5 ft. (3.2 m) of line,
Push or pull the line until the
line is evenly distributed, so
approximately 5 ft. (1.5 m) is
visible from both sides of the
cutting head.
Hold the cutting head knob
and turn the cutting head
clockwise to wind the line
around the spool until 5 in.
(12.7 cm) is protruding from
each side of the cutting head.
Align the arrows on the
cutting head knob with
the outerspool eyelets,
if they are not already.
Cutting
Head
Knob
Arrow
Eyelet
3 to 5 X
Min. 6"
Español — Page 9 English — Page 2Français — Page 5
Operator’s Manual
DO NOT RETURN THIS PRODUCT
For Assistance please call 1-800-800-7310 (U.S.) or 1-800-668-1238 (Canada)
or visit www.mtdproducts.com or www.mtdproducts.ca
NEED HELP? CALL 1-800-800-7310 IN U.S. OR 1–800–668–1238 IN CANADA
Y26CS
4-Cycle Trimmer
To Next Page
Need help?
General
