24 support@yardistrystructures.com
INSTALLING ROOFING MATERIAL
CAUTION!
Roong material may have sharp edges! Wear gloves!
HANDLE WITH CARE!
Place roong material on a non-abrasive surface before assembly as it
can bend, dent and scratch easily. Be sure to remove plastic covering
on both sides of the metal panels directly before installing each piece.
WARNING – DO NOT OVER TIGHTEN ROOFING SCREWS!
Over tightening screws will cause roong material to crush.
The roong screws can easily crush the Roof Panels and Roof
Edges when using a power drill. We recommend hand tightening the
roong screws so that they sit snug and tight to the roong material.
STOP STOPSTOP STOP
Overtightened and Crushed Snug and Tight
X
To Next Page
Loading...
