M10x20 (x4)
M8x25 (x2)
1
2
Panel (Bottom)
ø M16 × 238
(×1)
M10 × 20 × 4
1
M8 × 25 × 2
ø M16 × 238 × 1
2
× 2
M8 × 35 × 2
3
M8 × 30 × 2
Figure 4
Figure 5
PANEL (BOTTOM)
Position the bottom panel inside the mounting bracket. Align the
holes with the mounting bracket. Insert a long pin through holes
and secure each side with a at washer and cotter pin. (See Figure 4)
TIPPING HANDLE & ENGINE GUARD
Place the engine guard inside the mounting bracket and align
with the mounting bracket holes. Secure panel left side with two
M8x30 hex bolts, four washers and two nuts. Mount the tipping
handle on panel right side. Align holes and fasten with two M8x35
hex bolts, four washers and two nuts. (See Figure 5)
ASSEMBLY
This trackbarrow was partially assembled at the factory. To assemble your machine and the optional plow blade follow the below instructions.
Mount the handle frame assembly to the frame, and secure with
M10X20 bolts, washers and nuts at the front, and M8X25 bolts,
washers and nuts at the rear. (See
Figure 3
)
Figure 3
HANDLES
13
mm
17
mm
19
mm
12
mm
9
mm
30
mm
8
mm
× 2
8
mm
6
mm
9
YD8203PM01 - 1703
|
Assembly
09710US25M101.indd 9 2017/4/1 16:22:24
To Next Page
Loading...