Danger Area
Support Rod
Gas Spring
Guide Bracket
M8 × 35 × 2
4
Figure 6a
Figure 7
Figure 6c
Figure 6b
Insert the extendable sides into mounting slots located on the
bottom panel. (See Figure 6b)
Fasten each at the bottom with two L pins and jam nuts. (See
Figure 6c)
Unlock the jam nut and loosen the L pins. No need to remove the
L pins. (See Figure 6a)
Lift up the hopper and insert a support rod for safety purpose.
Align the holes in the gas spring with the holes in both guide
brackets and insert M8x35 bolts, washers and nuts to tighten.
(See Figure 7)
FRONT PANEL & EXTENDABLE LEFT/RIGHT SIDE GAS SPRING
13
mm
17
mm
19
mm
12
mm
9
mm
30
mm
8
mm
13
mm
17
mm
19
mm
12
mm
9
mm
30
mm
8
mm
PLOW BLADE (OPTIONAL – SOLD SEPARATELY)
Figure 8a
1. Mount the mounting bracket to the blade using M8×30
hex bolts, washers and nuts. (See Figure 8a)
M8 × 30 × 4
1
M8×30 (×4)
Mounting Bracket
13
mm
X 2
13
mm
17
mm
19
mm
12
mm
9
mm
30
mm
8
mm
× 2
10
Mini Tracked Dumper
»
Operator’s Manual
YD8203PM01 - 1703
Assembly
|
09710US25M101.indd 10 2017/4/1 16:22:27
To Next Page
Loading...