YARDMAX YD8203 - Trackbarrow Assembly Instructions; Plow Blade Assembly Steps

M10 × 25 × 2
5
M12 × 40 × 2
Figure 8e
7. Install the already assembled plow blade to the trackbarrow
as shown. (See Figure 8e)
Figure 8d
4. Attach control lever to the guide tube. Line up holes and
fasten with M8×35 bolt, washers and nut.
Support Bracket
Control Lever
Handle Grip
M8×35 (×1)
10×60 (×1)
M8 × 35 × 1
4
10 × 60 × 1
2 × 11 × 35 × 1
5. Insert the handle grip into the holder.
6. Secure the support bracket into the control lever with pin
10x60 and bridge clip.
(See Figure 8d)
17 mm
18 mm
30 mm
24 mm
13 mm
11 mm
X 2
M10×25 (×2)
M12×40 (×2)
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
17 mm
18 mm
30 mm
24 mm
13 mm
11 mm
Figure 8b
Figure 8c
3. Insert the shorter control lever into the longer lever. Align
holes and fasten with M8×40 hex bolt, washers and nut.
(See Figure 8c)
2. Position the pivot bracket inside the mounting bracket and
align with mounting bracket holes. Secure with M20×95
hex bolt, washers and nut. (See Figure 8b)
M8 × 40 × 1
3
M20 × 95 × 1
2
M8×40 (×1)
M20×95 (×1)
Pivot Bracket
17 mm
18 mm
30 mm
24 mm
13 mm
11 mm
X 2
17 mm
18 mm
30 mm
24 mm
13 mm
11 mm
X 2
11
YD8203PM01 - 1703
|
Assembly
09710US25M101.indd 11 2017/4/1 16:22:30