model no. 060-2279-2 | contact us: 1.866.523.5218 model no. 060-2279-2 | contact us: 1.866.523.5218
21
Troubleshooting
If your device is not operating properly, follow the instructions below. If this does not solve
the problem, please contact your local repair agent.
TOOL RUNS SLOWLY
• Check that the spool housing can rotate freely. Carefully clean it if necessary.
• Check that the cutting line does not protrude more than 4 1/2” (11 cm) from the spool
housing. If it does, cut it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK.
• Press the tabs and remove the spool cover from the housing.
• Pull the cutting line until it protrudes 4 1/2” (11 cm) from the housing. If insufficient cutting
line is left on the spool, install a new spool of cutting line as instructed in the Maintenance
section of this lowercase.
• Align the tabs on the spool cover with the cutouts in the housing.
• Push the cover onto the housing until it snaps securely into place.
• If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches
the blade.
• If the automatic line feed still does not work or the spool is jammed, try the following
suggestions:
• Carefully clean the spool cover and housing.
- Remove the spool and check if the lever can move freely.
- Remove the spool and unwind the cutting line, then wind it on neatly again as
described above. Replace the spool as instructed.
!
WARNING: Before proceeding, switch off and unplug.
To Next Page
Loading...
Need help?
General