Yardworks 14 A - Connecting Power and Controls

model number 054-5764-4 | contact us: 1.866.523.5218
19
It is important to use only the recommended oil to avoid damage to the chainsaw. Never
use recycled/old oil. Use of non-approved oil will invalidate the warranty.
OPERATION
1. ATTACHING EXTENSION CORD
1) Remove plug safety cap as shown (See Fig. F1). Insert extension cord socket into
chainsaw’s plug (See Fig. F2).
2) An extension cord retainer is attached to the handle to reduce strain on the cord. To use
this feature, simply double the extension cord as shown, about 12” (30 cm) from the end,
and insert it into the end of the retainer. Place the loop formed by doubling the cord over
UIFIPPL4FF'JH'(FOUMZUVHPOUIFDPSEUPFOTVSFUIBUJUJTªSNMZTJUVBUFEJOUIF
retainer (See Fig. F4).
3) Keep extension cord clear of operator, unit and any obstacles at all times.
Do not expose the cord to heat, oil, water, or sharp edges.
Assembly
Completed
F1
F2
F3 F4