model number 054-5764-4 | contact us: 1.866.523.5218
22
6. GENERAL CUTTING (See Fig. J1, J2)
"MXBZTIPMEUIFDIBJOTBXªSNMZXJUICPUIIBOET'SPOUHSJQXJUIUIFMFGUIBOEBOESFBSHSJQXJUI
the right hand. Fully grip both handles at all times during operation. Never operate chainsaw
using only one hand. Ensure power cord is located to the rear, away from the chain and wood
and so positioned that it will not be caught on branches or the like during cutting.
Use the chainsaw only with secure footing. Hold the chainsaw at the right-hand side of your
body.
The chain must be running at full speed before it makes contact with the wood. Use the metal
gripping teeth to secure the saw onto the wood before starting to cut. Use the spiked bumper
(9) as a leverage point while cutting. (See Fig. K)
Reset the gripping teeth at a low point when sawing thicker logs by pulling the chainsaw slightly
backwards until the gripping teeth release, and reposition at lower level to continue sawing.
• Do not remove the saw completely from the wood.
• Do not force the chain while cutting, let the chain do the work, using the gripping teeth to
apply minimal leverage pressure.
•
Do not operate the chainsaw with arms fully extended or attempt to saw areas which are
EJGªDVMUUPSFBDIPSPOBMBEEFS/FWFSVTFUIFDIBJOTBXBCPWFTIPVMEFSIFJHIU4FF'JH-
Assembly
Kickback Path
Kickback
Clear The
Work Area
Avoid
Obstructions
I1 I2
Stand to the
left of saw
thumb on
underside
of handlebar
J1 J2
To Next Page
Loading...
Need help?
General