is free from obstructions. Do not let the nose of
the guide bar contact a log, branch, fence, or any
other obstruction that could be hit while you are
operating the saw.
6. Always cut with the unit running at full speed.
Fully squeeze the switch trigger and maintain
cutting speed do not force.
7. With a basic understanding of kickback, you can
reduce or eliminate the element of surprise. Sudden
surprise contributes to accidents.
8. Keep proper footing and balance at all times.
9. Push and Pull – The reaction force is always
opposite to the direction the chain is moving
where wood contact is made. Thus, the operator
must be ready to control the PULL when cutting
on the bottom edge of the bar, and the PUSH
when cutting along the top edge. See
The rakers (depth gauges) ahead of each cutter can
minimize the force of a kickback reaction by pre-
venting the cutters from digging in too deeply at the
kickback zone. Only use a replacement chain that is
equivalent to the original chain.See
This saw comes equipped with a guide bar that has a small radius nose. Small radius noses generally have
less potential for kickback. When replacing the guide bar, be sure to order the bar listed in this manual.
1. Do not dismantle, open or shred battery pack.
with local codes for possible special disposal instructions.
3. Do not short-circuit a battery pack. Do not store battery packs haphazardly in a box or drawer where they
may short-circuit each other or be short-circuited by other metal objects. When battery pack is not in use,
keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal
objects, that can make a connection from one terminal to another. Shorting the battery terminals together
4. Do not subject battery pack to mechanical shock.
5. Observe the plus (+) and minus (–) marks on the battery back and equipment and ensure correct use.
6. Keep battery pack out of the reach of children.
7. Always purchase the battery pack recommended by the device manufacturer for the equipment.
8. Keep battery pack clean and dry.
9. Wipe the battery pack terminals with a clean dry cloth if they become dirty.
To Next Page
