14
WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a
serious injury.
WARNING:
Always wear eye protection with
side shields marked to comply with ANSI Z87.1,
along with hearing protection. Failure to do so
could result in objects being thrown into your eyes
and other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufactur-
er of this product. The use of attachments or ac-
cessories not recommended can result in serious
personal injury.
WARNING:
To prevent accidental starting
that could cause serious personal injury, always
the tank with oil.
WARNING:
NOTICE: If chain is too tight, it will not rotate.
Loosen the side cover knob slightly and turn
the tensioning knob once from right to left. Lift
the tip of the guide bar up and retighten the side
cover knob securely. Assure that the chain will
rotate without binding.
NOTICE:
designed for use on the bar and chain. This
can lead to a clogged oil system, which may
cause premature wear of the bar and chain.
oil level falls below the minimum line. Never
operate the chain saw if the oil is not visible.
Do not use dirty, used or otherwise contam-
inated oils. Damage may occur to the bar or
chain.
It is normal for oil to seep from the saw when
it is not in use. To prevent seepage, empty the
oil tank after each use, and then run the saw
with oil before use. Operating the chain saw with-
out chain oil or when the oil level is below the
minimum mark will result in damage to the chain
saw. Chain life and cutting capacity depend on
optimum lubrication. The chain is automatically
lubricated with chain oil during operation.
Before each use, inspect the entire product for dam-
aged, missing, or loose parts, such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and
caps and do not operate this product until all missing
or damaged parts are replaced.
j. Hold the tip of the guide bar up and tighten the
side cover knob securely. The chain is correctly
tensioned when there is no sag on the underside
of the guide bar and the chain is snug, but it can
be turned by hand without binding.
FILLING OILER WITH BAR
AND CHAIN LUBRICANT(Fig.
12)
a. Remove the battery pack from the chain saw.
b. Clean the oil tank cap and the area around it to
ensure that no dirt falls into the oil tank.
surface, so that the tank cap is facing upwards.
Rotate the oil tank cap counterclockwise to re-
move it.
d. Carefully pour the bar and chain oil into the tank.
slowly into the tank; be careful not to let the oil
neck.
f. Replace the cap, place the saw upright, and view
the level through the oil inspection window. Oil
OPERATION
To Next Page
