SAFETY INFORMATION
Please read and understand the entire manual before attempting to assemble, operate or install the
product. These safety instructions are not meant to cover every possible condition that could occur. If
you have any questions regarding the product please call customer service at 1-888-266-7096,
3
The purpose of safety signal statements and symbols is to attract your attention to possible danger. Read them
carefully to understand and practice proper accident prevention.
Signals an EXTREME hazard.
Failure to obey a safety DANGER signal WILL result in serious injury or death to yourself or to others.
Always follow the safety precautions to reduce the risk of fire, electric shock, and personal injury.
Signals a serious hazard.
Failure to obey a safety WARNING signal CAN result in serious injury to yourself and to others. Always
follow the safety precautions to reduce the risk of fire, electric shock, and personal injury.
Signals a moderate hazard.
Failure to obey a safety CAUTION signal MAY result in property damage or personal injury to yourself or to others.
Always follow the safety precautions to reduce the risk of fire, electric shock, and personal injury.
IMPORTANT! Signals special mechanical information.
NOTE: Signals additional important general information.
Safety Tool Symbols
IMPORTANT! Some of the following symbols may be used on your tool. Please study them and learn their meanings.
Proper interpretation of these symbols will allow you to operate the tool properly and safely.
~
CAUTION
WARNING
DANGER
Safety Signals
SYMBOL NAME EXPLANATION
Alternating Type or a characteristic of
current current
- - - Direct current Type or a characteristic of
current
Class II Designates double insulation
Ni-Cad Battery Designates that this tool is in
Recycling accordance with Ni-Cad
battery recycling program
SYMBOL NAME EXPLANATION
V Volt Potential voltage
A Amperes Current
Hz Hertz Frequency (cycles per
second)
n
0
No load speed Rotational speed at no load
.../min Movements Revolutions, strokes, surface
per minute speed, orbits, etc. per minute
8:30 a.m.-5:00 p.m. EST, Monday-Friday.
To Next Page
Loading...
Need help?
General