model no. 060-1983-0 | contact us: 1.866.523.5218model no. 060-1983-0 | contact us: 1.866.523.5218
12
3. Assembling the safety guard
Attach the safety guard to the trimmer head. Align the guard so it slides into the slots located on
the trimmer head. (see Fig. C1.) Secure the safety guard onto the trimmer head with the screw
provided. (see Fig. C2.)
BEFORE OPERATION
1. CHARGING THE BATTERY PACK
IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant; therefore, it must be fully charged
before using the rst time.
NOTE: If the battery pack is very hot, remove the battery from the charger and allow it to cool to
ambient temperature before attempting to recharge.
To prevent damage to the battery pack, please charge the battery to full or no less than half charge
before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. D)
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger; the light will begin ashing green to indicate the charging
process has started.
3) When charging is completed, the light will turn solid green. The pack is now fully charged; unplug
the charger and remove the battery pack.
Operation
WARNING:When battery charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the battery to cool
down before re-charging to achieve the full charge.
WARNING! Use caution when assembling the safety guard as the
guard has a very sharp line cutter.
WARNING! Never operate the tool without the guard properly in place.
Use of the unit without having installed the guard may result in injury.
A2
A1
B
E
E
G1
F
G3
G2
H
G4
I2
I1
I4
I3
J1
J2
C2
C1
1
2
1
2
1
1
2
Locking/
Release knob
Guide recess
13
14
30
0
2
1
To Next Page
Loading...
Need help?
General