1
VS−616G5
R
MC
S
T
THRX
OFF
ON
MC
∗∗
SA
12
MC
TRX
TRX
20 18
2
B1 B2
SA
SA
THRX
U (T1)
V (T2)
W (T3)
IM
12
BP
MC
≈
≈
Motor
Overload Relay Trip Contact
Braking Resistor Unit #
#
Ground (200V Class : 100Ω or less
400V Class : 10Ω or less)
3−Phase
Power Supply
200 to 230 V
50/60 Hz
or
380 to 460 V
50/60 Hz
L1 (R)
L2 (S)
L3 (T)
400/200 V
Overload Relay Trip Contact
of Braking Resistor Unit
Fault
Contact
DC Reactor
(Option)
Short−circuit
Bar
Use sequencer to break
power supply side on over-
load relay trip contact of
braking resistor unit.
Failure to observe this can
result in a fire.
The transformer is not necessary for 200V class.
Where is “E” or “V”.
When installing a DC reactor (option), remove the common bar between 1 and 2 terminals
(provided as standard) and connect a DC reactor with the terminals.
When using the braking resistor unit, set constant L3−04 to “0” (stall prevention selection during
decel is disabled). If it is not changed, the inverter may not stop within set decel time.
MCCB
Fig. 14 For Models CIMR-G5∗20P4 to -G5∗27P5 (200 V Class 0.55 to 7.5 kW),
Models CIMR-G5∗40P4 to -G5∗4015 (400 V Class 0.4 to 15 kW)
To Next Page
Loading...
Need help?
General