YASKAWA CIMR-G5A 2015 - PG-X2 (for Flux Vector Control Mode Only); PG-X2 Terminal Specifications

Wiring
3.7.2 PG Speed Control Card Terminal Blocks
3-26
J
PG-X2 (For Flux Vector Control Mode Only)
Table 3.13 PG-X2 Terminal Specifications
Terminal No. Contents Specifications
1
12 VDC (±5%), 200 mA max. (see note)
2
Power supply for pulse generator
0 VDC (GND for power supply)
3
pp y
p
g
5 VDC (±5%), 200 mA max. (see note)
4
A-phase + input terminal
T
A1
5
A-phase − input terminal
TA1
6
B-phase + input terminal
Line driver in
p
ut
(
RS-422 level in
p
ut
)
7
B-phase − input terminal
Line
driver
input
(RS 422
level
input)
Maximum response frequency: 300 kHz
8
Z-phase + input terminal
9
Z-phase − input terminal
10
Common terminal 0 VDC (GND for power supply)
1
A-phase + output terminal
2
A-phase − output terminal
3
B-phase + output terminal
Line
driver
output
(RS 422
level
output)
TA2
4
B-phase − output terminal
Line driver output (RS-422 level output)
5
Z-phase + output terminal
6
Z-phase − output terminal
7
Control circuit common Control circuit GND
TA3 (E)
Shield connection terminal

Note 5 VDC and 12 VDC cannot be used at the same time.
3