9 Electrical Installation
YASKAWA TOEPC71061723A YASKAWA AC Drive CR700 Quick Start Guide 45
◆ Terminal Configuration
Control circuit terminals should are arranged as shown in the following figure.
A - Terminal block (TB2-3)
B - Terminal block (TB2-2)
C - Terminal block (TB2-1)
D - Terminal block (TB1)
E - Terminal block (TB3)
F - Terminal block (TB4)
Figure 9.18 Control Circuit Terminal Arrangement
The tightening torque for terminals is displayed on the reverse side of the front cover.
Figure 9.19 Tightening Torque Display (the Reverse Side of the Front Cover)
Figure 9.20 Tightening Torque Display (the below side of the front cover)
■ Control Circuit Wire Gauges and Tightening Torques
Use the tables in this section to select the correct wires. Use shielded wire to wire the control circuit terminal
block. Use crimp ferrules on the wire ends to make the wiring procedure easier and more reliable.
EN
To Next Page
Loading...
