YASKAWA MECHATROLINK-II V1000 - Page 17

5 Installation Procedure
YASKAWA ELECTRIC TOBP C730600 49A V1000 Option MECHATROLINK-II Installation Manual 17
◆ Wiring Diagram
Figure 4
Figure 4 Wiring Diagram
<1> The FE terminal on the MECHATROLINK-II Option is supplied with a ground cable that should be connected to
the ground terminal on the drive.
If there are noise influences on communication, remove the grounding cable.
SI-T3/V
CN3
FE
<1>
NC
SRD−
SRD+
NC
NC
SRD−
SRD+
NC
NC
SRD−
SRD+
NC
MECHATROLINK
Master
Drive
Terminater
MECHATROLINK-II
Communication
Cable
shielded line
control circuit terminal