3
PG speed controller card, PG-X2 is mounted on the control board of the inverter,
and performs speed feedback using the pulse generator (PG) on the motor to cor-
rect speed fluctuations caused by slipping. Motor rotation direction is detected
by phase A and phase B PG pulse inputs. The card is used for flux vector control.
This option card is applicable to the following inverter series:
VS−616G5: Entire series
Name Code No. Functions
PG speed
controller card
PG−X2
73600−A015X
S Applicable to RS-422 output PG
S Phase A and phase B pulse (2−phase pulse)
inputs for vector control
S Maximum input frequencyrange : 50 to
300kHz
S Pulse monitor output: RS-422 output
Terminal TA3
(for connecting
shielded sheath)
Terminal block
TA1
Terminal block
TA2
Spacer mounting
hole (3.2mm dia.)
Variable resistor for
adjusting +5V power
Spacer mounting
hole (3.2mm dia.)
Connector to inverter
control board (4CN)
Spacer mounting
hole (4.0mm dia.)
Variable resistor for
adjusting +12V power
Grounding lead wire
(connected to pin #12
of inverter control board)
Fig.
1 PG speed controller card PG-X2
Verify that the attachment below is in the package.
S Spacer : 1 pc. (Dimentions in mm)
14.4
5 33.6 5.7
Fig.
2 Spacer (code no. SRNT41028−9)
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
