32
Disconnection (DISCONNECT)
The DISCONNECT command is used to close the connection and move to phase 1.
After moving to phase 1, no check for transmission faults is executed.
This command can be used in phases 2 and 3.
If this command is received while in phase 2 or 3, the data for the control command to the
Inverter is cleared to 0, and a fault reset command is carried out for the Inverter.
Byte Command Response
1 DISCONNECT DISCONNECT
2 ALARM
3 STATUS
4
5
6
7
8
9
10
11
12
13
14
15
16 WDT RWDT
To Next Page
Loading...
