46
Other Faults
The following table shows other faults that can be detected by the SI-T.
If a warning occurs, operation will follow the previous command.
* If the ERR indicator is not lit or flashing, any commands that are received will be ignored.
ALARM Description Fault Type Operation when Fault Occurs
94 Data setting warning Communications warning Received commands are ignored.
95 Command warning Communications warning Received commands are ignored.
EC WDC fault with Inverter Communications alarm Waits for power supply to be reset.
ED Inverter access permission fault
(Access not possible 10 consecutive times)
Communications alarm Waits for power supply to be reset.
EE Inverter monitor timer over (1 s elapsed) Communications alarm Waits for power supply to be reset.
Received commands are ignored.*
To Next Page
Loading...
Need help?
General