To Next Page

To Previous Page

English

STARTING THE ENGINE

Please follow all the instructions as mentioned below when starting your Mini-Motorbike.

Operation

1. Make sure the gears are in neutral (You can check this by pushing the Mini-Motorbike forwards and

backwards. When it is in any other gear, the Mini-Motorbike will not move from its stationary

position without drive from the engine)

2. Turn the fuel tap lever to the "ON" position.

3. If the engine is cold, pull up the CHOKE to engage the lever.

4. Kick-start the Mini-Motorbike while at the same time letting off some gas.,To achieve this, use your

right foot to firmly and quickly press down on the kick-start lever. Due to the smaller,size of the

Mini-Motorbike, there is no need to apply excessive force to kick the engine over.

5. After warming up the engine for a short time, return the choke lever to its original position.

6. Never use the kick-starter on a hot day or when the engine is warm/warmed up. Just twist the

throttle grip to kick the engine over.

Caution: Be very careful not to over-use the choke, as damage to the engine and cylinder threads may occur.

Questions and Answers:

Need help?

Do you have a question about the YCF F190SPIII and is the answer not in the manual?

YCF F190SPIII Specifications

General