| Call Features | 22
2.
Highlight the desired file and select Play.
The length of the recording and a progress bar are displayed as the recording plays.
Pausing/Resuming a Playback
When you are playing a recording, you can pause it manually to take note.
1.
Select Pause to pause the playback.
2.
Select Play to restart the playback.
Fast Forwarding/Rewinding a Playback
While a recording plays, you can fast forward or rewind the playback at any time.
Do the following:
•
Select to skip forward the playback. Tap once to skip forward 1 minute.
•
Select to rewind the playback. Tap once to rewind 1 minute.
Deleting a Recorded Call
You can delete the recordings when you need additional space on your SD card or the recordings are useless.
1.
Go to Menu > Record > Browse Audio.
2.
Highlight the desired recording and select Delete.
The phone prompts you whether to delete the audio.
3.
Confirm the action.
Viewing the Available Recording Time
To avoid the recording failed due to timeout, you can view the storage space of the SD card, and check the available
recording time before recording.
Go to Menu > Record > Storage Space.
Multicast Paging
Multicast Paging allows you to broadcast instant audio announcements to users who are listening to a specific
multicast group on a specific channel.
The phone supports the following 31 channels:
• 0: Broadcasts are sent to channel 0.
• 1 to 25: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broadcasting
with Polycom IP phones which have 25 channels you can listen to.
• 26 to 30: Broadcasts are sent to channel 26 to 30. We recommend that you specify these channels when
broadcasting with Yealink IP phones running firmware version 81 or later running new firmware version (new
paging mechanism).
Note: All IP phones in the multicast paging group must be deployed in the same subnet since a broadcast
is used. The phone can only send/receive broadcasts to/from the listened channels. Other channels’
broadcasts will be ignored automatically by the IP phone.
Sending Multicast Paging
You can send paging to the phones with pre-configured multicast addresses on specific channels.
Your system administrator has set the paging group for your phone.
1.
Go to Menu > Features > Pagine List.
If your system administrator has set only one paging list, the paging is sent directly.
2.
Select the desired paging group.
To Next Page
Loading...
Need help?
General
